Hello,
I am trying to turn a bunch of .jpegs into a 3D file. It worked yesterday with fewer files - however I did get this warning and the GUI popped up... but it successfully generated the 3D file through the GUI.
[rossisl@nialbn-01878557 JPEG]$ to3d *.jpg -orient SAL
++ to3d: AFNI version=AFNI_16.1.07 (Apr 25 2016) [64-bit]
++ Authored by: RW Cox
++ It is best to use to3d via the Dimon program.
** Can't find file -orient
** Can't find file SAL
++ Counting images: total=546 2D slices
++ Each 2D slice is 2160 X 2560 pixels
++ Image data type = byte
++ Reading images: ..........................................
*+ WARNING: *** ILLEGAL INPUTS (cannot save) ***
Axes orientations are not consistent!
++ Making widgets.....
Today, with the complete set of files, this is what I'm getting and the GUI won't pop up - even if I only input the filename.
[rossisl@nialbn-01878557 newborn_neurons]$ to3d *.jpg -orient SAL
++ to3d: AFNI version=AFNI_16.2.18 (Sep 19 2016) [64-bit]
++ Authored by: RW Cox
++ It is best to use to3d via the Dimon program.
** Can't find file -orient
** Can't find file SAL
++ Counting images: total=2362 2D slices
++ Each 2D slice is 2160 X 2560 pixels
++ Image data type = byte
++ Reading images:
Fatal Signal 11 (SIGSEGV) received
T3D_read_images
to3d:main
Bottom of Debug Stack
** Command line was:
to3d Aged_10000.jpg Aged_10001.jpg Aged_10002.jpg ... -orient SAL
** AFNI version = AFNI_16.2.18 Compile date = Sep 19 2016
** [[Precompiled binary linux_openmp_64: Sep 19 2016]]
** Program Death **
** If you report this crash to the AFNI message board,
** please copy the error messages EXACTLY, and give
** the command line you used to run the program, and
** any other information needed to repeat the problem.
** You may later be asked to upload data to help debug.
** Crash log is appended to file /home/rossisl/.afni.crashlog
[rossisl@nialbn-01878557 newborn_neurons]$
Do I not have enough memory because there are so many files?
Thanks in advance!