Thank you!
I fixed the qvars to only indicate one centered variable and updated my model name to indicate table-level variable names only. I also deleted variables from the table that weren't called in this simpler model in case that was also causing an issue?
I have a couple follow up questions. In the past using 3dLME, I had conditions specified under the table name (e.g., "Ant" as the table name and "rew" and "pun" as sub-conditions). Is that not the case or have I not properly specified "rew" and "pun" were being called from the "Ant" column? I added in a few of the subjects to reference where the "rew" and "pun" are coming from. I'm getting the same error, about table size so I know I'm still not indicating it correctly, but confused how else to specify those subconditions.
Thanks again!
3dLME -prefix 3dLME_v1 \
-model "Ant*grade_c" \
-resid grade_resids \
-ranEff '~1+grade_c' \
-SS_type 3 \
-qVars "grade_c" \
-qVarsCenters "0" \
-mask \
-num_glf 1 \
-glfLabel 1 'Ant_grade' -glfCode 1 'Ant : 1*rew & 1*pun grade_c :' \
-dataTable \
Subj Ant grade_c Inputfile \
001 rew 1 /Volume/DSNLab/NeuroTeen/subs/wave1/NT1001/con_001.nii \
001 pun 1 /Volume/DSNLab/NeuroTeen/subs/wave1/NT1001/con_002.nii \
001 neu 1 /Volume/DSNLab/NeuroTeen/subs/wave1/NT1001/con_003.nii \
003 rew 1 /Volume/DSNLab/NeuroTeen/subs/wave1/NT1003/con_001.nii \
003 pun 1 /Volume/DSNLab/NeuroTeen/subs/wave1/NT1003/con_002.nii \
003 neu 1 /Volume/DSNLab/NeuroTeen/subs/wave1/NT1003/con_003.nii \
003 rew 3 /Volume/DSNLab/NeuroTeen/subs/wave3/NT3003/con_001.nii \
003 pun 3 /Volume/DSNLab/NeuroTeen/subs/wave3/NT3003/con_002.nii \
003 neu 3 /Volume/DSNLab/NeuroTeen/subs/wave3/NT3003/con_003.nii \