AFNI Message Board

History of AFNI updates  

|
October 22, 2020 11:14AM
Problem solved,
the program died with

3dDeconvolve -input pb05.imapt1s080.r01.scale+orig.HEAD -mask full_mask.imapt1s080+orig -ortvec motion_demean.1D mot_demean -ortvec motion_deriv.1D mot_deriv -polort 4399 -float -num_stimts 0 -fout -tout -x1D X.xmat.1D -xjpeg X.jpg -fitts fitts.imapt1s080 -errts errts.imapt1s080 -x1D_stop -bucket stats.imapt1s080
++ 3dDeconvolve extending num_stimts from 0 to 12 due to -ortvec
++ 3dDeconvolve: AFNI version=AFNI_20.2.15 (Aug 28 2020) [64-bit]
++ Authored by: B. Douglas Ward, et al.
++ Skipping check for initial transients
++ Input polort=4399; Longest run=659814.0 s; Recommended minimum polort=4399 ++ OK ++
++ Number of time points: 277 (no censoring)
 + Number of parameters:  4412 [4412 baseline ; 0 signal]
** ERROR: Regression model has too many parameters for dataset length :(
** FATAL ERROR: 3dDeconvolve dies: Insufficient data (277) for estimating 4412 parameters
** Program compile date = Aug 28 2020

It seems that the TR was in ms instate of s...
for future people that might have the same problem:

3drefit -TR 2.382 dset_func

I just have my last question left concerning mALFF,
thank you!

Clément
Subject Author Posted

BOLD resolution for afni_proc.py

Doughboys October 20, 2020 05:22PM

Re: BOLD resolution for afni_proc.py

Doughboys October 22, 2020 11:14AM

Re: BOLD resolution for afni_proc.py

ptaylor October 22, 2020 11:36AM

Re: BOLD resolution for afni_proc.py

ptaylor October 22, 2020 11:35AM

Re: BOLD resolution for afni_proc.py

Doughboys October 22, 2020 02:04PM

Re: BOLD resolution for afni_proc.py

ptaylor October 22, 2020 04:14PM

Re: BOLD resolution for afni_proc.py

Doughboys October 22, 2020 04:53PM

Re: BOLD resolution for afni_proc.py

ptaylor October 22, 2020 06:00PM

Re: BOLD resolution for afni_proc.py

Doughboys October 28, 2020 02:44PM

Re: BOLD resolution for afni_proc.py

ptaylor October 28, 2020 04:04PM

Re: BOLD resolution for afni_proc.py

Doughboys October 29, 2020 09:02PM



Sorry, only registered users may post in this forum.

Click here to login