hi, my 3dmvm fails due to model test failure. Basically, I have one between-subs factor and two within-sub factors. My model specification is presented below. Would appreciate any ideas about how it can be changed.
3dMVM -prefix Apathy -jobs 24 \
-model group \
-wsVars 'trialtype*apathy' \
-num_glt 3 \
-gltLabel 1 tbi_apathy_high-low -gltCode 1 'group : 1*tbi apathy : 1*high -1*low' \
-gltLabel 2 hc-tbi_apathy_low -gltCode 2 'group : 1*hc -1*tbi apathy : 1*low' \
-gltLabel 3 hc-tbi_apathy_high -gltCode 3 'group : 1*hc -1*tbi apathy : 1*high' \
-dataTable \
Subj group trialtype apathy InputFile \
hc008 hc congruent low /mnt/netshare/imaging/apathy_TBI_NJCBIR/data/hc008/task_data/stroop.glt+tlrc'[5]' \
tbi001 tbi congruent low /mnt/netshare/imaging/apathy_TBI_NJCBIR/data/tbi001/task_data/stroop.glt+tlrc'[5]' \
tbi006 tbi congruent high /mnt/netshare/imaging/apathy_TBI_NJCBIR/data/tbi006/task_data/stroopR.glt+tlrc'[5]' \