Hi,
We are acquiring resting state epi on a new prisma scanner.
The acquisition is set to multi slice.
I am trying to figure out what do use for the tpattern parameter in to3d.
From the dicom .nfo file the timings are:
(but I am not sure if this is the right thing to look at)
MosaicRefAcqTimes FD 0.00000000 210.00000001 420.00000000 630.00000000 840.00000000 70.00000001 280.00000000 490.00000001 700.00000000 910.00000000 140.00000000 350.00000001 560.00000000 770.00000000 0.00000000 210.00000001 420.00000000 630.00000000 840.00000000 70.00000001 280.00000000 490.00000001 700.00000000 910.00000000 140.00000000 350.00000001 560.00000000 770.00000000 0.00000000 210.00000001 420.00000000 630.00000000 840.00000000 70.00000001 280.00000000 490.00000001 700.00000000 910.00000000 140.00000000 350.00000001 560.00000000 770.00000000 0.00000000 210.00000001 420.00000000 630.00000000 840.00000000 70.00000001 280.00000000 490.00000001 700.00000000 910.00000000 140.00000000 350.00000001 560.00000000 770.00000000
thanks, Justin