AFNI Message Board

Dear AFNI users-

We are very pleased to announce that the new AFNI Message Board framework is up! Please join us at:

https://discuss.afni.nimh.nih.gov

Existing user accounts have been migrated, so returning users can login by requesting a password reset. New users can create accounts, as well, through a standard account creation process. Please note that these setup emails might initially go to spam folders (esp. for NIH users!), so please check those locations in the beginning.

The current Message Board discussion threads have been migrated to the new framework. The current Message Board will remain visible, but read-only, for a little while.

Sincerely, AFNI HQ

History of AFNI updates  

Previous Message Next Message
Message List New Topic Print View
|
samw
May 10, 2021 05:02AM
Hello!

Is there a default value for the parameter -bandpass in 3dTProject?

I ran the commands

3dTproject -input bold_orig.nii.gz -polort 1 -prefix bold_project_1.nii.gz

3dTproject -input bold_orig.nii.gz -polort 1 -prefix bold_project_2.nii.gz -bandpass 0 1

I expected bold_project_1 and bold_project_2 to have exactly the same voxel values, but they don't, so I'm wondering if the command above without -bandpass uses a range different than [0 1].

Thank you!

Best regards,
Sam
Reply Quote
RSS
Subject Author Posted

default value for 3dTProject bandpass

samw May 10, 2021 05:02AM

Re: default value for 3dTProject bandpass

ptaylor May 10, 2021 04:31PM