AFNI Message Board

Dear AFNI users-

We are very pleased to announce that the new AFNI Message Board framework is up! Please join us at:

https://discuss.afni.nimh.nih.gov

Existing user accounts have been migrated, so returning users can login by requesting a password reset. New users can create accounts, as well, through a standard account creation process. Please note that these setup emails might initially go to spam folders (esp. for NIH users!), so please check those locations in the beginning.

The current Message Board discussion threads have been migrated to the new framework. The current Message Board will remain visible, but read-only, for a little while.

Sincerely, AFNI HQ

History of AFNI updates  

|
May 10, 2017 12:46PM
Hi, everyone~

I have exactly the same problem: 0.7 mm iso T1, freesurfer surfaces are OK, but SurfVol+orig is only 1x1x1 by @SUMA_Make_Spec_FS -sid $subj.

1) Is it a problem?
2) Shall I 3dresample SurfVol+orig to 0.7 mm?
3) Is there a way to get 0.7 mm SurfVol+orig natively out of @SUMA_Make_Spec_FS?

Thanks a lot!
Subject Author Posted

Problem with conforming of voxel size to 1x1x1 using @SUMA_Make_Spec_FS

AMaallo September 10, 2015 02:09AM

Re: Problem with conforming of voxel size to 1x1x1 using @SUMA_Make_Spec_FS

herrlich10 May 10, 2017 12:46PM