afni.nimh.nih.gov

I get an error for specifying fbot ftop as 0.01 and 0.1 respectively in 3dRSFC. same bandpass works fine in Instacorr for the time series used. any insights? I am suspecting program may not expect in Hz even though the manual says so. error message below

++ 3dRSFC (from 3dBandpass by RW Cox): version THETA: AFNI version=AFNI_16.1.06 (Apr 19 2016) [64-bit]
++ Authored by: PA Taylor
++ Data length = 7680 FFT length = 7680
+ bandpass: ntime=7680 nFFT=7680 dt=2.5 dFreq=5.20833e-05 Nyquist=0.2 passband indexes=192..1920
++ Loading input dataset time series
++ Number of voxels in automask = 31784
++ Checking dataset for initial transients [use '-notrans' to skip this test]
+ No widespread initial positive transient detected
++ Bandpassing data time series
++ Creating output dataset in memory, then writing it
++ Output dataset ./RSFC_dspk_detrend_pct_tcat_in_D99_errts_censorkmeans_rbebase+tlrc.BRIK
++ Bandpassing data time series
** ERROR: bandpass: fbot and ftop too close ==> jbot=0 jtop=-2147483648 (df=0.000052)
++ Creating output dataset 2 in memory
++ Starting the (f)ALaFFel calcs