AFNI Message Board

Dear AFNI users-

We are very pleased to announce that the new AFNI Message Board framework is up! Please join us at:

https://discuss.afni.nimh.nih.gov

Existing user accounts have been migrated, so returning users can login by requesting a password reset. New users can create accounts, as well, through a standard account creation process. Please note that these setup emails might initially go to spam folders (esp. for NIH users!), so please check those locations in the beginning.

The current Message Board discussion threads have been migrated to the new framework. The current Message Board will remain visible, but read-only, for a little while.

Sincerely, AFNI HQ

History of AFNI updates  

|
ns
May 22, 2017 05:26PM
Hmmmm. But the IRF output for CSPLINzero has 6 parameters: the 1st and 6th are 0 and then the are betas are at 1,2,3,4. So- are you saying that in 3dDeconvolve when we specify the "lag" (see below), we are supposed to change from 2..4 to 1..3? That seems OK, but is that documented anywhere do you know? thanks, nicola

So, for instance, following the -gltsym command, we were putting the lags of the STIM we wanted to use in the test.
Stim[2..7] = means put +1 in the matrix for lags 2..7 of Stim
Subject Author Posted

3dDeconvolve and General Linear Test (GLTsym) problem

ns May 16, 2017 04:05PM

Re: 3dDeconvolve and General Linear Test (GLTsym) problem

ns May 19, 2017 10:04AM

Re: 3dDeconvolve and General Linear Test (GLTsym) problem

rick reynolds May 19, 2017 11:46AM

Re: 3dDeconvolve and General Linear Test (GLTsym) problem

rick reynolds May 19, 2017 11:54AM

Re: 3dDeconvolve and General Linear Test (GLTsym) problem

ns May 22, 2017 05:26PM

Re: 3dDeconvolve and General Linear Test (GLTsym) problem

ns May 22, 2017 05:27PM

Re: 3dDeconvolve and General Linear Test (GLTsym) problem

rick reynolds May 22, 2017 08:01PM

Re: 3dDeconvolve and General Linear Test (GLTsym) problem

ns May 23, 2017 01:37PM

Re: 3dDeconvolve and General Linear Test (GLTsym) problem

rick reynolds May 23, 2017 04:40PM