I am very sorry for so many questions. But now I have only the last two questions to verify:
1. The inverse matrix, NOT the forward matrix is outputted to the terminal by
3dWarp -verb?
2. I can change the deobliqued dataset to match the original dataset perfectly using the following codes?
#3dWarp -oblique2card -prefix card OriginalAnatomy+orig.
cat_matvec -ONELINE card+orig::WARPDRIVE_MATVEC_INV_000000 > inversion.1D
3dAllineate -1Dmatrix_apply inversion.1D -prefix reoblique+orig -source card+orig -master OriginalAnatomy+orig
3drefit -atrcopy OriginalAnatomy+orig. IJK_TO_DICOM_REAL reoblique+orig
Am I right about these two questions?
Best regards,
Yu
Edited 6 time(s). Last edit at 01/05/2019 12:58PM by Zhang Yu.
