AFNI Message Board

Dear AFNI users-

We are very pleased to announce that the new AFNI Message Board framework is up! Please join us at:

https://discuss.afni.nimh.nih.gov

Existing user accounts have been migrated, so returning users can login by requesting a password reset. New users can create accounts, as well, through a standard account creation process. Please note that these setup emails might initially go to spam folders (esp. for NIH users!), so please check those locations in the beginning.

The current Message Board discussion threads have been migrated to the new framework. The current Message Board will remain visible, but read-only, for a little while.

Sincerely, AFNI HQ

History of AFNI updates  

|
February 23, 2021 11:19AM
Hi-

Can you please provide a bit more details:
+ what is your 3dTproject command? or are you using this via afni_proc.py?
+ how many time points are you starting with?
+ what is the actual output message in the terminal (you are only outputting code blocks of variables, not the output numbers).

MIN_RUN is set to 9 in the code, I believe-- are you getting down to less than 9 degrees of freedom? How many is your number of "points after censoring"? (You don't put the actual output, just the code involved).

--pt
Subject Author Posted

Censoring error in 3dTproject

Karelo February 23, 2021 05:12AM

Re: Censoring error in 3dTproject

ptaylor February 23, 2021 11:19AM