Hi, Alessia-
Grazie per gli commenti multilingue! Mi dispiace a fare la riposta nel inglese, solamente...
Can you describe a bit more about your segments, the surface ROIs? Were they created on the standard meshes output by SUMA (std.141* or std.60*)? If so, they are essentially already "projected" onto other subjects surfaces. You can load them on any subject's standard mesh, and they should fit over/within the corresponding node IDs.
Some of these things (drawing ROIs on surfaces and using standard meshes) are covered in these Bootcamp videos:
[
www.youtube.com]
Specifically, standard surfaces:
[
www.youtube.com]
Drawing ROIs:
[
www.youtube.com]
(and subsequent ones show scripting things).
--pt
Edited 1 time(s). Last edit at 04/15/2021 11:03AM by ptaylor.