Hi,
just to confirm again:
-1Dfile ename Save the motion parameters ONLY in file 'ename'.
The output is in 6 ASCII formatted columns:
roll pitch yaw dS dL dP
Hence, column 1 starts with roll and column 6 ends with dP. Correct?
I am asking this again because if I use the following code:
Results 1dplot -volreg dfile_rall.1D
1dplot -sepscl -volreg dfile_rall.1D
It plots:
A-P in the first row;
R-L in the second row;
I-S in the third row;
Yaw in the fourth row;
Pitch in the fith row;
Roll in the sixth row
The plotting order (from row one to the last row) does not match the column order (left to right) described above.
Two questions.
1. Does the plotting order (top to bottom row) simply not follow the column order (left to right)?
2.
Does "dS" correspond to the y-axis translation?
Does "dL" correspond to the x-axis translation?
Does "dP" correspond to the z-axis translation?
Thanks,
Philipp