AFNI Message Board

Dear AFNI users-

We are very pleased to announce that the new AFNI Message Board framework is up! Please join us at:

https://discuss.afni.nimh.nih.gov

Existing user accounts have been migrated, so returning users can login by requesting a password reset. New users can create accounts, as well, through a standard account creation process. Please note that these setup emails might initially go to spam folders (esp. for NIH users!), so please check those locations in the beginning.

The current Message Board discussion threads have been migrated to the new framework. The current Message Board will remain visible, but read-only, for a little while.

Sincerely, AFNI HQ

History of AFNI updates  

|
August 18, 2003 07:57PM
When I looked at the output of to3d, my functional file that had 21 axial slices only showed data for slices 0-14 and all the slices above (superior) were blank. The raw data file was the right size. There was no problem with other functional data from the same scanning session. Any ideas or suggestions?
Subject Author Posted

to3d problem

wiveka ramel August 18, 2003 07:57PM

Re: to3d problem

bob cox August 19, 2003 09:20AM

Re: to3d problem

wiveka ramel August 19, 2003 05:19PM

Re: to3d problem

bob cox August 19, 2003 05:27PM