Dear,
I am a beginner in AFNI.
Today, I do 3dreg to correct movement artifact in my data.
After it, I look the data and find 'new movement and peak' on superior edge areas, which are not observed in original data.
I repeat it but the results are same.
I think these new peaks seem to be within acceptable range movement.
My questions are
1. Is there any way to solvee this problem?
2. Could I include this data into my group map?
-I think I should not include this data into my group map.
3. If there is no way to solve it, can I include original data NOT registered
data into my group map?
Thanks in advance,
Sukkyoon