Hi ho. I've got a brik that's been reoriented the way I want, but the
origin is still wrong and I want to shift it a little. Is there a
command I can use to set the origin of the brik?
[Long story: these briks have been 3dtagaligned to a master, but the
coordinate system is not perfectly centered on the origin I want.
Aligning the tags solves a different problem than the one I should
solve, but the results are quite close. In fact in one example I have,
the origin is about 4 mm away from where it should be. So I just want to
shift the origin a bit.]
--
Tom Holroyd, Ph.D.
I would dance and be merry,
Life would be a ding-a-derry,
If I only had a brain.
-- The Scarecrow
------------------------------------------
Posted to Phorum via PhorumMail