AFNI Message Board

Dear AFNI users-

We are very pleased to announce that the new AFNI Message Board framework is up! Please join us at:

https://discuss.afni.nimh.nih.gov

Existing user accounts have been migrated, so returning users can login by requesting a password reset. New users can create accounts, as well, through a standard account creation process. Please note that these setup emails might initially go to spam folders (esp. for NIH users!), so please check those locations in the beginning.

The current Message Board discussion threads have been migrated to the new framework. The current Message Board will remain visible, but read-only, for a little while.

Sincerely, AFNI HQ

History of AFNI updates  

|
Daniel Glen
December 21, 2009 03:37PM
3dZcutup and 3dZcat can extract and combine slices, respectively. If your slices are not stored in anterior to posterior or the reverse, you can use 3dresample to an orientation that is.
Subject Author Posted

looking for afni route to solve this issue

Jian Lin December 21, 2009 02:48PM

Re: looking for afni route to solve this issue

Daniel Glen December 21, 2009 03:37PM

Re: looking for afni route to solve this issue

Jian Lin December 21, 2009 04:08PM

Re: looking for afni route to solve this issue

Daniel Glen December 21, 2009 04:38PM

Re: looking for afni route to solve this issue

Jian Lin December 21, 2009 05:02PM

Re: looking for afni route to solve this issue

Daniel Glen December 21, 2009 05:49PM