Dear AFNI users,
I get a 3dDeconvolve WARNING message when I used the '-ortvec bandpass_rall.1D bandpass' option:
*+ WARNING: !! in Signal+Baseline matrix:
* Largest singular value=2.66744
* 3 singular values are less than cutoff=2.66744e-07
* Implies strong collinearity in the matrix columns!
*+ WARNING: !! in Baseline-only matrix:
* Largest singular value=2.66744
* 3 singular values are less than cutoff=2.66744e-07
* Implies strong collinearity in the matrix columns!
Note that the 3dDeconvolve command is running well without the bandpass filter option. I don't understand what the problem is.
Do you think I could use the -GOFORIT option run it until the end?
Many thanks for any answer.
Carole
