AFNI Message Board

Dear AFNI users-

We are very pleased to announce that the new AFNI Message Board framework is up! Please join us at:

https://discuss.afni.nimh.nih.gov

Existing user accounts have been migrated, so returning users can login by requesting a password reset. New users can create accounts, as well, through a standard account creation process. Please note that these setup emails might initially go to spam folders (esp. for NIH users!), so please check those locations in the beginning.

The current Message Board discussion threads have been migrated to the new framework. The current Message Board will remain visible, but read-only, for a little while.

Sincerely, AFNI HQ

History of AFNI updates  

Previous Message Next Message
Message List New Topic Print View
|
patrick.rollo@uth.tmc.edu
April 22, 2019 04:18PM
Sorry for the delay, the code we used is below, it was run through matlab:

system(['3dVol2Surf -spec ' paths.vol.S2 'surfaces/TandonLang/' patient '/SUMA_std/std.125.' patient '_both.spec -surf_A rh.pial.asc -sv ' paths.vol.S2 patient '/afni/' patient '_anatr1_shifted_coords+orig.BRIK -grid_parent ' paths.vol.S2 patient '/afni/' patient 'v1mr+orig.BRIK -map_func mask -out_1D ' paths.vol.S2 patient '/afni/' patient '_R_v1mr_surface.1D']);

I'm not sure what you mean but going back, but as I said, the above code is what we are having trouble with.

Sorry again for taking so long to reply!

Thank you
Reply Quote
RSS
Subject Author Posted

3dVol2Surf

patrick.rollo@uth.tmc.edu April 16, 2019 02:45PM

Re: 3dVol2Surf

rick reynolds April 16, 2019 04:48PM

Re: 3dVol2Surf

patrick.rollo@uth.tmc.edu April 22, 2019 04:18PM

Re: 3dVol2Surf

rick reynolds April 23, 2019 04:18PM