Hi,
I ran my afni_proc_py script and found an error message during the 3Ddeconvolve stage. The error message reads "-polort: Command not found". What is puzzling to me is that in my afni_proc_py script, it says explicitly to use “-polort 5”. There is also an error message in the results folder called “3dDeconvolve.err” which reads” *+ WARNING: Input polort=1; Longest run=676.2 s; Recommended minimum polort=5” I am confused about this discrepancy since my script defines a values of 5 and am wondering what I should do. Could this be a potential problem with using dmBlock functions?
Thanks for any advice!
Sven
PS: I have attached my afni_proc_py script if that helps....
