Colm Connolly wrote:
> What I had been doing is the following
>
> 1. afni -niml&
> 2. suma -spec N27_both_tlrc.spec -sv TT_N27+tlrc. &
> 3. Load functional overlay in afni
> 4. Open axial, sagittal and coronal views in afni
> 5. In suma window press t to elicit the error, which still
> happens with this sequence and today's afni/suma build.
Following the above sequence of actions with
GPL AFNI: Analysis of Functional NeuroImages, by RW Cox (rwcox@nih.gov)
This is Version AFNI_2008_07_18_1710
[[Precompiled binary macosx_10.5_Intel_64: Nov 19 2009]]
produced the following error message
+++ NOTICE: SUMA_ijk: 334060 triangles attached
to surface rh.white.tlrc. (#5),
session /Users/colmconn/src/suma_tlrc/
I/O time = 111 ms, Processing = 5 ms
--------------------------------------------------
received too many surfaces for LDP 'lh.smoothwm.tlrc.ply (via SAME)'
using surf #0 : lh.smoothwm.tlrc.ply
using surf #1 : lh.pial.tlrc.ply
ignoring surf #4 : lh.white.tlrc.ply
--------------------------------------------------
received too many surfaces for LDP 'rh.smoothwm.tlrc.ply (via SAME)'
using surf #2 : rh.smoothwm.tlrc.ply
using surf #3 : rh.pial.tlrc.ply
ignoring surf #5 : rh.white.tlrc.ply
--------------------------------------------------
received too many surfaces for LDP 'lh.smoothwm.tlrc.ply (via SAME)'
using surf #0 : lh.smoothwm.tlrc.ply
using surf #1 : lh.pial.tlrc.ply
ignoring surf #4 : lh.white.tlrc.ply
--------------------------------------------------
received too many surfaces for LDP 'rh.smoothwm.tlrc.ply (via SAME)'
using surf #2 : rh.smoothwm.tlrc.ply
using surf #3 : rh.pial.tlrc.ply
ignoring surf #5 : rh.white.tlrc.ply
***********************
AFNI cross hair notice:
From Afni:
Surface: lh.pial.tlrc.ply
Node: 99657, XYZ: 0.00 15.00 10.00
In Controller [A]:
Surface: lh.smoothwm.tlrc.ply, adopted: lh.smoothwm.tlrc.ply
Node: 99657, XYZ: 0.00 15.00 10.00
