afni.nimh.nih.gov
AFNI Message Board
Dear AFNI users-
We are very pleased to announce that the new AFNI Message Board framework is up! Please join us at:
Existing user accounts have been migrated, so returning users can login by requesting a password reset. New users can create accounts, as well, through a standard account creation process. Please note that these setup emails might initially go to spam folders (esp. for NIH users!), so please check those locations in the beginning.
The current Message Board discussion threads have been migrated to the new framework. The current Message Board will remain visible, but read-only, for a little while.
Sincerely, AFNI HQ
We are very pleased to announce that the new AFNI Message Board framework is up! Please join us at:
https://discuss.afni.nimh.nih.gov
Existing user accounts have been migrated, so returning users can login by requesting a password reset. New users can create accounts, as well, through a standard account creation process. Please note that these setup emails might initially go to spam folders (esp. for NIH users!), so please check those locations in the beginning.
The current Message Board discussion threads have been migrated to the new framework. The current Message Board will remain visible, but read-only, for a little while.
Sincerely, AFNI HQ
| November 13, 2020 01:55PM | |
thanks, Daniel-
yes I'd tried @RetinoProc, but not much and now I'll try again with newfound knowledge. it seems to do a lot, however. my idea was to specify most of the preprocessing with afni_proc and then pick up with the Retino stuff where it leaves off (e.g. I've been inputting pb*.scale* files into 3dRetinoPhase). do you foresee any problems with this approach? i predict the answer is "depends on what you want to do"
-Sam
yes I'd tried @RetinoProc, but not much and now I'll try again with newfound knowledge. it seems to do a lot, however. my idea was to specify most of the preprocessing with afni_proc and then pick up with the Retino stuff where it leaves off (e.g. I've been inputting pb*.scale* files into 3dRetinoPhase). do you foresee any problems with this approach? i predict the answer is "depends on what you want to do"
-Sam
| Subject | Author | Posted |
|---|---|---|
|
storrisi | October 27, 2020 01:27PM |
|
storrisi | October 28, 2020 09:23PM |
|
storrisi | November 01, 2020 01:44PM |
|
Daniel Glen | November 10, 2020 09:15AM |
|
storrisi | November 13, 2020 01:55PM |
